The MACHIN Command [MLEPCS]

The MACHIN command can been used to select the desired post-processor for creation of the final tape file. The GENER Launch Panel and command line parameters support the automatic selection of the post-processor from MACHIN commands in the CL file.

This command is valid for all machine types.

\textbf{MACHIN / } \mathit{post\_name}\; \big[,\mathit{post\_id}\,\big] \; {\small \sim}\!\begin{bmatrix} ,\! \begin{array}{l} \mathit{keyword} \\ \mathit{value} \\ \mathit{text} \end{array} \;\end{bmatrix}

The post_name and post_id combination must match the responses given for the post-processor name and identification number in the “General Information” section in QUEST. The post_name parameter is the unquoted 1-32 character case insensitive name of the post-processor. The optional post_id specifies the post-processor identification number in the range 1-999999. Omit this for post- processors that do not have an identification number.

For example, if the post-processor was saved under the name “MYPOST,3”, then identify the post-processor on the MACHIN command as follows:

MACHIN/MYPOST,3

GENER ignores any parameters following the name specification.